Dr. Michael Kroll's Mobile Computing Forum

CC Debugger and BLE
Page 1 of 1

Author:  dwolb [ Tue Sep 25, 2012 4:36 am ]
Post subject:  CC Debugger and BLE


I am trying to have my CC Debugger recognize my BLE module.

The BLE module is powered by 3V and the target sense voltage, GND, reset, P2_2, and P2_1 are wired to the debugger, but the debugger does not recognize the module.

Are there any tips on using this debugger?

Thanks for any help!

Author:  davidseth [ Wed Sep 26, 2012 3:10 am ]
Post subject:  Re: CC Debugger and BLE

Take a look at this post to see if it helps: http://blog.bluetooth-smart.com/2012/09 ... using-iar/



Author:  Phooto [ Wed Sep 26, 2012 2:15 pm ]
Post subject:  Re: CC Debugger and BLE

I can only assume that you don't have the other connections on the BLE112 module. Ground connections are not necessarily made inside the module, you should connect all the GND and power lines as appropriate, not just the ones to the debugger.

So, Pin 1,2,3,4,5,9,10,20,21,29 & 30 should all have connections.

Author:  dwolb [ Fri Sep 28, 2012 4:13 am ]
Post subject:  Re: CC Debugger and BLE

Thanks to you both, CC Debugger shows "green"! (the debugger recognized the BLE112!)

Author:  davidseth [ Fri Sep 28, 2012 6:09 am ]
Post subject:  Re: CC Debugger and BLE

Good to hear. Can you take a picture and post it of your rig? I have been having some difficulties as well with mine working consistently so would welcome a picture! Thanks.

Author:  dwolb [ Sat Sep 29, 2012 12:47 am ]
Post subject:  Re: CC Debugger and BLE

Sure! Couldn't get the picture to upload native onto the website:

http://imgur.com/xw52v [img]

Sorry for the mess!

Author:  fred [ Sun Jun 09, 2013 10:25 pm ]
Post subject:  Re: CC Debugger and BLE

I connected with success the BLE113 (!!) to CC-Debugger by 6 pin: AVDD/DVDD with CC-2/CC-9, P2_1 with CC-4 , P2_2 with CC-3,GND with CC-1 and RESET with CC-7.
I assume, this is the same with BLE112.

Page 1 of 1 All times are UTC + 1 hour [ DST ]
Powered by phpBB® Forum Software © phpBB Group