Dr. Michael Kroll's Mobile Computing Forum
http://forum.mkroll.mobi/

BLE Shield - getting error when trying to program Arduino
http://forum.mkroll.mobi/viewtopic.php?f=1&t=9
Page 1 of 1

Author:  rosenjon [ Wed Aug 08, 2012 1:23 am ]
Post subject:  BLE Shield - getting error when trying to program Arduino

I get the following error when trying to program my Arduino Uno while the BLE Shield is attached:

avrdude: stk500_getsync(): not in sync: resp=0xe0

Not sure what this means. If I unplug the shield, program the Arduino, and then plug in the shield, everything works as planned. However, this is annoying to have to do every time I want to reprogram the Arduino. Any ideas what's wrong?

Author:  mkroll [ Wed Aug 08, 2012 9:41 am ]
Post subject:  Re: BLE Shield - getting error when trying to program Arduin

Does the error persistif you switch the serial switch from position 0/1 to 2/3 before reprogramming the Arduino?

Page 1 of 1 All times are UTC + 1 hour [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/